specifications of boilers

Steam
DZL series biomass-fired steam boiler

Product thermal capacity:2 – 20t/h
Working pressure:1 - 2.5 MPA

Read More
Hot water
DZL series biomass-fired hot water boiler

Product thermal capacity:1.4 - 14 MW
Working pressure:1.0-1.6 MPA

Read More
Steam
SZL series biomass-fired steam boiler

Product thermal capacity:4-35 t/h
Working pressure:1.0-2.5 MPA

Read More
Hot water
SZL series biomass-fired hot water boiler

Product thermal capacity:2.8-29 MW
Working pressure:1.0-1.25 MPA

Read More
Steam
DHL series biomass-fired steam boiler

Product thermal capacity:20-75 t/h
Working pressure:1.25-5.4 MPA

Read More
Thermal fluid
YLW series biomass-fired thermal fluid heater

Product thermal capacity:1400-29000 KW
Working pressure:0.8-1.0 MPA

Read More

Classifications of Boilers - Engineering ToolBox

Section IV Heating Boilers - commercial boilers, industrial boilers, heating boilers, low pressure boilers. boilers in which steam or other vapor is generated at a pressures not exceeding 15 psig ; high temperature water boilers intended for operation at pressures not exceeding 160 psig and or temperatures exceeding 250 degrees F

lexie@zozen.com > Get A Quote >

PROCESS DESIGN OF STEAM BOILERS (PROJECT STANDARDS AND ...

PROCESS DESIGN OF STEAM BOILERS (PROJECT STANDARDS AND SPECIFICATIONS) Page 3 of 45 Rev: 01 April 2011 SCOPE This Project Standards and Specifications is intended to cover minimum requirements for process design of field erected water tube boilers. REFERENCES Throughout this Standard the following dated and undated standards/codes are referred to.

lexie@zozen.com > Get A Quote >

Characteristics of boiler feedwater - Lenntech

The composition of boiler feed water must be such that the impurities in it can be concentrated a reasonable number of times inside the boiler, without exceeding the tolerance limits of the particular boiler design. If the feed water does not meet these requirements it must be pretreated to remove impurities.

lexie@zozen.com > Get A Quote >

BOILER TYPES AND CLASSIFICATIONS - myodesie.com

Hotwater boilers that have temperatures not exceeding 250° Fahrenheit or pressures not exceeding 160 psig are called ''low temperature hot water boiler''s. Heating boilers are also classified as to the method of manufacture, i.e., by casting (cast iron boilers) or fabrication (steel boilers). Those that are cast usually use iron, bronze, or ...

lexie@zozen.com > Get A Quote >

Boiler Specification | Specification (Technical Standard ...

This specification covers the minimum requirement and basis of design to be used for the boilers in Bushehr Petrochemical, Utility and Offsite Plant Project. This specification defines the minimum requirements for the design, manufacture, inspection, testing and supply of the Steam Boilers for the onshore scope.

lexie@zozen.com > Get A Quote >

DRAFT BOILER/FEEDWATER GUIDELINES - National Board of Boiler ...

pitting can result with possible rupture of boiler condensate piping or boiler tubes. 3.3.4 Rusty water in the boiler gage glass is a sure sign of acid corrosion in the boiler feedwater/condesate system or in the boiler itself. 3.3.5 Make-up water is the major source of carbon dioxide. The first priority is to minimize the amount of make-up water.

lexie@zozen.com > Get A Quote >

View Boiler Specifications - Nationwide Boiler Inc.

View Nationwide Boiler's rental boiler and auxiliary equipment specifications for pictures, connection sizes, and other important information. View Boiler Specifications - Nationwide Boiler Inc. Nationwide Boiler Inc.

lexie@zozen.com > Get A Quote >

Hurst Boiler | Boiler Models| Plan Views | Spec Sheets

High temperature water purged from the boiler’s “surface” blow-off system carries valuable heat energy that is normally lost to the drain. A Hurst Boiler Heat Recovery System can reclaim this discarded wasted energy and transfer it to the boiler make-up water to increase of overall efficiency.

lexie@zozen.com > Get A Quote >

Boilers (industrial) Specifications | Engineering360

Find Boilers (industrial) on GlobalSpec by specifications. Industrial boilers are closed vessels that use a fuel source or electricity to heat water or generate steam for industrial heating and humidification applications.

lexie@zozen.com > Get A Quote >

Boiler Guide Specifications - Johnston Boiler

Boiler Guide Specifications; Boiler Formulas; Emissions; Firetube Boiler Advantages; Hot Water Boiler – Policy Statements; JBC Feedwater Valve;

lexie@zozen.com > Get A Quote >

links: